CEI Conrad Electronic International Limited RCE-NAVIGATOR Manuale Utente

22  |  Eyecontrol:navigator App

The Navigator 250 is now ready for its first flight. You are strongly advised to read through

before the first take-off.

Basic (Magenta)

Expert (Orange)

GPS (Blue)

 Flight battery low
 

(White) Level 1: 1 Hz,  

Level 2: 5 Hz

 Errors
   

(Red)

 R.T.H. activated
 

(White) 0.5 Hz

 GPS signal quality (Rear LED)
 

Optimal

Good

Weak

No signal

Idle alarm
If the copter is left idle in operation state for a minimum of 10 min. it

will emit warning signals. Remove and install the flight battery again.

If you purchased an ArF version you need a RC Logger R8 Radio Transmitter (89102RC).

 

Should you not have one already, you can purchase it from

www.rclogger.com

.

Note  that  the  receiver  included  with  the  R8  Radio  Transmitter  set  89102RC  is  not

compatible with the Navigator 250. The Navigator 250 has a built-in receiver and an ArF

user only needs to pair the R8 Radio Transmitter with the Navigator 250.

 

The EYEControl: Navigator app is available in the Google Playstore for Android mobile

devices and in the Apple App Store for iOS devices under the name ‘EYEControl: 

Navigator’.

 

Make sure the app is compatible with your device before you attempt to install it.

 

The app includes instructions and tutorials as well as step-by-step calibration guidance.

1.  Turn on Bluetooth

®

on your mobile device and start the EYEControl:Navigator app

 

▬

When using an Android device, additionally turn on ‘Location’ service.

2.  Insert and connect the flight battery.

3.  Press and hold the pairing button (left button) (24) until ‘Navigator’ is shown on the

PAIRING page in the app (around 5 to 10 sec).

4.  Once the Bluetooth

®

connection has been established, the app switches to the landing

page and displays ‘Connected’ and firmware version.

5.  Pairing is completed.