CEI Conrad Electronic International Limited RCE-NAVIGATOR Manuale Utente

24  |  Calibration

The Navigator 250 is calibrated in a 3-step procedure:

 

D

Make sure the flight battery is fully charged.

1.  Remove the propellers.

2.  Transmitter: Set travel of all channels to ‘+ –100 %’ and trims to ‘0’.

3.  Transmitter: Make sure that the throttle stick is in its mid-position (the sticks are spring

loaded and are centered by default).

4.  Transmitter: Set all switches and knobs to their default positions (switches: position 1,

knobs: turn fully anti-clockwise).

5.  Install the flight battery and turn the transmitter on.

The calibration button is integrated into the right rear LED (right button (25)). Press and

hold the button to enter calibration mode. Press 2 times quickly to start calibration. Press

1 time to skip/go to next calibration step. Refer to »Fig. 9.

 

D

When you calibrate the Navigator 250 for the first time you must not skip any steps.

However, at a later point in time this feature may become useful when you want to calibrate

only one item (e.g. compass) but not the others.

Calibrate

Calibrate

Calibrate

Channel learning

Compass

Gyro

Fig. 9

There are two ways you can enter the calibration mode:

 

Calibration button (right button): Press and hold it for at least 2 seconds. The rear LEDs

turn solid red (channel learning).

 

Transmitter  switch  ‘SWB’:  Flip  the  switch  5x  from  1  to  3  and  back  to  1.  Channel

Learning is entered automatically.

The rear LEDs indicate each calibration step.

Channel learning 

(Red)

Gyro 

(Green)

Compass 

(Magenta)