CEI Conrad Electronic International Limited RCE-NOVAX350 Manuale Utente

32  |  Calibration

When  using  a  6-channel  transmitter,  trigger  R.T.H.  by  turning  the  transmitter  off.
Additionally, set channel 5 to +30 % in the ‘fail safe’ status. Refer to the user instructions
of your transmitter and receiver.

In case you do not have a free 3-way toggle switch available on your transmitter, you may
assign a 2-way-toggle-switch instead and shift your channel END POINT after performing 
the learning procedure on your transmitter. See [ Fig. 11 ].

> By default the END POINT for channel 5 (flight mode switch) is set to “135 100”. This

default setting lets the 2-way-toggle-switch function as the bank selection switch (AP
mode, Sport mode). 

> To toggle between these two modes instead, simply shift the END POINT to “0 100”

for the affected switch. See [ Fig. 11 ].

> You may use the same approach for channel 6 (AP, Sport and Custom mode).

LINKAGE MENU         1/2 

SERVO  

:  SUB-TRIM 

MODEL SEL.  :  REVERSE 

MODEL TYPE  :  FAIL SAFE

FREQUENCY   :  END POINT

FUNCTION   :  THR CUT

END POINT  

  2/2 

AUX1 0   100  6  100  135 

AUX2 135 100  7  100  135

AUX3 135 100  8  100  135

AUX4 135 100   100 135

Fig. 11

1.  Study [ Fig. 12 ].
2.  Switch to the gyro calibration procedure. Refer to

.

3.  Start the procedure.
4.  Replace the canopy.
5.  Place the »NovaX 350 on a horizontal and level surface [1] and wait for a single beep.
6.  Rotate the »NovaX 350 by 180° about its vertical axis [2] [3] .
7.  2 beeps confirm the successful completion of the gyro calibration procedure.
8.  Remove the canopy.
9.  Complete the procedure.

1.  Study  [ Fig. 13 ].
2.  Switch to the compass calibration procedure. Refer to 

3.  Start the procedure.
4.  Replace the canopy.