EMW Co. Ltd BHA-WN400 Manuale Utente
87
3. SETUP
1) MODULE NO : User can change the module by using [-, +] button.
2) PICONET ID : User can change the ID by using [-, +] button.
-
This ID is used for establishing wireless connection and it is chageable. But the ID
must match IP Camera’s ID in order to establishing the succesful wireless connection.
3) FREQUENCY : Selectable from 2.4GHz, 5.8GHz, and 2.4/5.8GHz.
4) Channel : Selectable from AUTO, MANUAL
-
AUTO : Automatically allocated to the channels.
-
MANUAL : Manually allocated to the channels.
5) RF POWER : User can set the RF power of the module.
-
Low power settings are suggested when the distance from IP Camera to NVR is
close and High power settings are suggested when the distance from IP Camera to
NVR is far.
6) ENCRYPTION : User can choose whether the wireless signal transmission will use
encryption feature or not. Enabling this feature may decrease the wireless transmission
rate by a little.
7) CHANNEL AVOIDANCE : User can choose whether the wireless signal transmission will use
channel avoidance feature or not.
-
If the channel setting is on “Manual”, this feature will not be enabled.
8) MODULE REBOOT : NVR forces the wireless module to reboot by clicking this button.