Unique Broadband Systems Ltd. DRU2KW Manuale Utente
Page 40
X75 SERIES - Mk3 Controller
INSTALLATION & OPERATING MANUAL
Manual No. x75mk3-11
x75-man-Rev11-0815.indd
13.5 Alarm Matrix
When the Alarm Matrix menu item is selected the following two section page will
be displayed.
Figure 22 - Alarm Matrix WEB Applet (typical)
The top section presents 5 tabs where limits relating to temperature, voltage, current
and minimum number of rectifiers (Other Alarms tab) can be defined. Note that as
the X75 has no Analog inputs the Analog Input Alarm tab, while displayed when
selected, should be left as default.
The bottom section is used to route the various alarms to alarm relays, front panel
LEDs, Email targets and an audible buzzer. Alarms may be routed to single or
multiple destinations by selecting the desired check boxes.
The following applies to all tabs and matrix configuration.
To upload any changes, click on UPLOAD. An administrator level password is
required.
To get default values for the parameters, click on DEFAULT. These will not be
applied unless UPLOAD is clicked.
When resetting to default it is important that the correct system voltage is selected
when asked.