Omnitracs LLC IVG2 Manuale Utente
80-JE026-1 Rev. J
MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION
68
Send a Manual CER Event
1. From the Home screen, tap the Critical Event Reporting button. Tap Yes to initiate an
event.
The CER message is sent to the Omnitracs network operations center.
2. Verify that the host receives the CER event message and that data is present.
Events Triggered in Error
For hard braking events triggered in error, verify configuration values, hard braking minimum
speed and hard braking deceleration rate.
speed and hard braking deceleration rate.
False hard braking events are typically caused by a faulty speed sensor.
For stability control events triggered in error, verify configuration values minimum speed and
on/off threshold.
on/off threshold.
Roll stability events are sent from the power train or braking control units installed on the truck.
The IVG system acts as a pass-through for these devices. If false events are recorded, those
devices should be investigated. Configuration settings can be changed to filter and prevent
erroneous events. Call Omnitracs Support for assistance.
The IVG system acts as a pass-through for these devices. If false events are recorded, those
devices should be investigated. Configuration settings can be changed to filter and prevent
erroneous events. Call Omnitracs Support for assistance.