Olympus Winter & Ibe GmbH ESG200 Manuale Utente
40
System settings
Buttons
Function
SELECT
PROCEDURE
Selecting previously saved, preferred settings.
FOOT
SWITCH
Assigning the foot switch and Autostart.
MENU
Save Procedure
Saving or overwriting of output settings.
Delete Procedure
Deleting previously saved settings.
Languages
Selecting the preferred language.
Available languages: English, Japanese, German,
Chinese, French, Italian, Spanish and Portuguese.
Touch Tone
Activating or deactivating the audible feedback when
tapping the touch screen.
Autostart Setup
Setting a time delay for Autostart.
Software Version
Showing information about the installed software
version.
Safety Test
Opening or closing the output relays. Required for
the annual safety check.
Bipolar Cut Setup
Switching the cutting modes for the BIPOLAR
socket on or off.
Service
Accessing the service screen. For the technical
service only. This screen is password protected.
Volume control for
output tone
Increasing or decreasing of the volume of the output
tone.
Brightness control
Increasing or decreasing of the brightness of the
touch screen.
Table: Overview of system settings
5.3 Select Procedure settings
Use this function to select procedure settings that were saved previously.
Figure 5.2 Screen [Select Procedure]
There are no factory settings provided for this function. If no settings are saved, the
message [No procedure saved] is displayed on the screen [Select Procedure]. Refer to the
section “Save Procedure - Saving and overwriting procedure settings” on page 42.
DRAFT
–
2017-01-17