NEOSEN ENERGY EZI Manuale Utente

The transmitter is attached to the sheet with a 100% silicone adhesive. Place 
dabs of silicone at each of the four corners. Clear or translucent adhesive is 
recommended, white is shown here for visibility. Avoid highly contrasting 
colors, particularly dark adhesive with more translucent, lighter- colored sheets. 
There needs to be enough silicone to fill the gap between the flange and the 

surface. Keep the silicone away 

from the coil. If for some reason 
the transmitter will be replaced, 
removal will be easier if the 
adhesive is only on the flange and 
not in the cavity. If desired, small 
amounts of hot melt adhesive 
may be placed along opposite 
sides to hold the transmitter in 
place while the silicone adhesive 
cures. The hot melt can be 
applied at the edges of the flange 
after the transmitter is placed in 
the pocket. The transmitter may 
be held in place with tape or a 
weight while the silicone cures. 

D.2. Wiring 

The transmitter is supplied with a power cord consisting of DC and AC wiring 
connected with a transformer. In many cases an AC power outlet may need to