ZyXEL Wireless Access Point G1000 91-005-124003B Manuale Utente
Codici prodotto
91-005-124003B
G-1000 User’s Guide
Chapter 13 LAN Setup
101
Figure 54 Menu 3.2 TCP/IP Setup
Follow the instructions in the following table on how to configure the fields in this menu.
13.3 Wireless LAN Setup
Use menu 3.5 to set up your G-1000 as the wireless access point. To edit menu 3.5, enter 3
from the main menu to display Menu 3 – LAN Setup. When menu 3 appears, press 5 and then
press [ENTER] to display Menu 3.5 – Wireless LAN Setup as shown next.
from the main menu to display Menu 3 – LAN Setup. When menu 3 appears, press 5 and then
press [ENTER] to display Menu 3.5 – Wireless LAN Setup as shown next.
Menu 3.2 - TCP/IP Setup
IP Address Assignment= Static
IP Address= 192.168.1.2
IP Subnet Mask= 255.255.255.0
Gateway IP Address= 0.0.0.0
IP Address Assignment= Static
IP Address= 192.168.1.2
IP Subnet Mask= 255.255.255.0
Gateway IP Address= 0.0.0.0
Table 42 Menu 3.2 TCP/IP Setup
FIELD
DESCRIPTION
IP Address
Assignment
Press [SPACE BAR] and then [ENTER] to select Dynamic to have the G-1000
obtain an IP address from a DHCP server. You must know the IP address assigned
to the G-1000 (by the DHCP server) to access the G-1000 again.
Select Static to give the G-1000 a fixed, unique IP address. Enter a subnet mask
Select Static to give the G-1000 a fixed, unique IP address. Enter a subnet mask
appropriate to your network and the gateway IP address if applicable.
IP Address
Enter the (LAN) IP address of your G-1000 in dotted decimal notation
IP Subnet Mask
Your G-1000 will automatically calculate the subnet mask based on the IP address
that you assign. Unless you are implementing subnetting, use the subnet mask
computed by the G-1000.
Gateway IP
Address
Type the IP address of the gateway. The gateway is an immediate neighbor of your
G-1000 that will forward the packet to the destination. On the LAN, the gateway
must be a router on the same network segment as your G-1000.
When you have completed this menu, press [
ENTER
] at the prompt “Press ENTER to Confirm…” to
save your configuration, or press [
ESC
] at any time to cancel.