Renkforce Funk-Wetterstation mit Wetterforecast Wireless Weather Station AOL-5052B Scheda Tecnica

Switching the Alarm Function On/Off
•  Push the button „MODE“ (A) sevaral times until either the alarm time 1 (display „A1“

to the right of the alarm time) or the alarm time 2 (display „A2“ to the right of the alarm

time) is displayed.

•  Briefly press the button „-“ to activate or deactivate the alarm function.
 If alarm time 1 is on, the symbol „

“ appears on the right of the display.

 If alarm time 2 is on, the symbol „

“ appears on the right of the display.

Activate Snooze Function or Terminate Alarm
•  The alarm signal is activated at the set alarm time and the bell symbol „

“ (for alarm

time 1) or „

“ (for alarm time 2) flashes.

•  Pushing the button „SNOOZE/LIGHT“ (G) interrupts the alarm signal for the duration

of 5 minutes. During this time, the bell symbol continues to flash.

 Then the alarm signal is started again.
 This procedure can be repeated several times.
•  To terminate the alarm signal (or snooze mode), push any button on the rear of the

weather station.

 The alarm signal is automatically terminated after 2 minutes if no button is

pushed.

An upper and lower temperature limit can be set for each of the outdoor sensor channels

(1, 2, 3) and an alarm signal can be emitted when the value leaves the range.
•  First select the desired outdoor sensor channel with the button „CHANNEL“ (E).
•  If you keep the button „-“ pushed for 3 seconds, „ON“ or „OF“ will flash to the left of

the display in the outdoor temperature display area. Release the button again.

•  Use the button „+“ or „-“ to switch the temperature alarm on („ON“) or off („OF“).
•  Briefly push the button „MODE“ (A). The temperature value for the upper temperature

limit flashes, and the symbol „ “ appears above the time.

•  Set the upper temperature limit with the buttons „+“ and „-“. Keep the respective

button pressed for quick adjustment.