Insys GSM LOGO 4.2 Compact 11-02-01-03-04.001 Manuale Utente
Codici prodotto
11-02-01-03-04.001
INSYS GSM 4.2 LOGO!
Commisioning
Dezember 06
25
4.2
Firmware Update
The firmware for the INSYS GSM 4.2 LOGO! as well as the flashloader software
and the associated operator’s guide can be found on the supplied CD-ROM.
and the associated operator’s guide can be found on the supplied CD-ROM.
4.3
Commissioning
The easiest way to perform initial commissioning is to use the HSComm GSM
LOGO! parameter assignment software.
Perform the following steps:
1. Have the SIM card and PIN number ready (but do not use yet).
2. Connect the INSYS GSM and the PC using the serial cable (male/female).
LOGO! parameter assignment software.
Perform the following steps:
1. Have the SIM card and PIN number ready (but do not use yet).
2. Connect the INSYS GSM and the PC using the serial cable (male/female).
Connect the GSM antenna.
3. Connect the voltage supply to the 10 to 60 VDC terminals and the negative
pole to GND, and switch on.
4. Initialization begins.
• Connect LED illuminates for approximately 4 s.
• After an additional 8 s, the Status LED starts flashing for approximately 20
• After an additional 8 s, the Status LED starts flashing for approximately 20
s.
• Then, the Status LED goes out because an SIM card is not inserted and a PIN
is not stored.
• The Signal LED illuminates or flashes depending on the strength of the
GSM network.
5. Start HSComm in Windows: