DJI Quadcopter RtF incl. GPS, incl. camera Inspire 1 with 2RC Scheda Tecnica

©

 2014 DJI. All Rights Reserved. 

Aircraft

INSPIRE 1

  User Manual

Battery Level Indicators while Charging

LED1

LED2

LED3

LED4

Battery Level

 

0%~25%

 

 

25%~50%

 

 

 

50%~75%

 

 

 

 

 

75%~100%

 

Fully Charged

Charging Protection LED Display

The table below shows battery protection mechanisms and corresponding LED patterns. 

Battery Level Indicators while Charging

LED1 LED2 LED3 LED4 Blinking Pattern

Battery Protection Item

LED2 blinks twice per second 

Over current detected

LED2 blinks three times per second Short circuit detected

LED3 blinks twice per second

Over charge detected

LED3 blinks three times per second Over-voltage charger detected

LED4 blinks twice per second

Charging temperature is too low 

(<0°C)

LED4 blinks three times per second Charging temperature is too high 

(>40°C)

After any of the above mentioned protection issues are resolved, press the button to turn off the Battery 

Level Indicator. Unplug the Intelligent Flight Battery from the charger and plug it back in to resume 

charging. Note that you do not need to unplug and plug the charger in the event of a room temperature 

error, the charger will resume charging when the temperature falls within the normal range. 

DJI does not take any responsibility for damage caused by third-party chargers.

How to discharge your Intelligent Flight Battery:

To effectively calibrate the battery capacity, it is recommended to charge and discharge the 

battery thoroughly for every 10 charge-and-discharge cycle. User should install the battery onto 

the aircraft and then power on the aircraft to initiate the discharge process, discharge the battery 

until the aircraft is powered off automatically. User should then fully charge the battery to ensure 

the battery is working at its optimal.

Slow: Place the Intelligent Flight Battery into the Inspire 1’s Battery Compartment and power it 

on. Leave it on until there is less than 5% of power left, or until the battery can no longer 

be turned on. Launch the DJI Pilot app to check battery level.

Rapid: Fly the Inspire 1 outdoors until there is less than 5% of power left, or until the battery can 

no longer be turned on.