Insys GSM 4.2 Compact 11-02-01-03-04.002 Manuale Utente
Codici prodotto
11-02-01-03-04.002
INSYS GSM 4.2
INSYS GSM 4.2 compact
INSYS GSM 4.2 compact
Configuration Software HSComm GSM
Sep-06
45
Send settings
Use the button "Send values" to transmit the current settings in the HSComm to the IN-
SYS GSM.
Use the button "Send values" to transmit the current settings in the HSComm to the IN-
SYS GSM.
Note
The settings for the menu item PLC may only be transmitted using
the buttons "Configure GSM device at the PLC" or "Configure PC
modem".
The settings for the menu item PLC may only be transmitted using
the buttons "Configure GSM device at the PLC" or "Configure PC
modem".
Read settings
Use the button "Read settings" to read the current settings from the INSYS GSM. The cur-
rent settings are displayed in the HSComm.
Use the button "Read settings" to read the current settings from the INSYS GSM. The cur-
rent settings are displayed in the HSComm.
Send default settings
Use the button "Send default values" to load the default factory settings into the INSYS
GSM. A reset will be executed.
If the PIN was stored, the device will immediately afterwards log into the GSM network.
Use the button "Send default values" to load the default factory settings into the INSYS
GSM. A reset will be executed.
If the PIN was stored, the device will immediately afterwards log into the GSM network.
Reset
Use the button "Reset" to start a reset of the INSYS GSM.
If the PIN was stored, the device will immediately afterwards log into the GSM network.
Use the button "Reset" to start a reset of the INSYS GSM.
If the PIN was stored, the device will immediately afterwards log into the GSM network.
Synchronize RS232
The serial interfaces of the INSYS GSM and the configuration must be configured equally.
Use the button "Synchronize RS232" to test all possible baud rate and data format set-
tings at the PC side until both sides match.
The serial interfaces of the INSYS GSM and the configuration must be configured equally.
Use the button "Synchronize RS232" to test all possible baud rate and data format set-
tings at the PC side until both sides match.
Abort
Use the button "Cancel" to cancel running data transmissions, e.g. for "Send values" or
"Read settings".
Use the button "Cancel" to cancel running data transmissions, e.g. for "Send values" or
"Read settings".
5.3.3 Status bar
The status bar at the lower window border of the HSComm displays the setting and ac-
tivities of the serial interface of the configuration PC.
The LEDs RX and TX of the INSYS GSM light up synchronously during the receiving and
sending of data.
tivities of the serial interface of the configuration PC.
The LEDs RX and TX of the INSYS GSM light up synchronously during the receiving and
sending of data.
5.3.4 Tabs
The settings of the basic and extended settings are spread across several tabs, which can
be selected via the tab titles.
be selected via the tab titles.
The settings will be transmitted to the INSYS GSM when you click on the button "Send
values".
The functions are described in detail in the chapter "Functions and their configuration".
values".
The functions are described in detail in the chapter "Functions and their configuration".