Ideal Electrical TightSight Digital-Multimeter, DMM, 61-765 Scheda Tecnica

6

The meter beeps and lights an LED when measuring > 30V AC on the VAC function and >30V

DC when on the VDC function.

Notes: This feature does not work in the Ohm, capacitor, continuity or clamp modes. Audible

indication can be disabled by pressing and holding the Max/min button while turning the func-

tion switch from OFF to any desired Function. Wait for Hb to be displayed and then release the 

button. To enable, turn the unit off and back on.

Press the Hold button on the side of the meter to toggle in and out of the data hold mode.

“HOLD” appears in the upper left of the meter display when data hold is active. Use the data

hold feature to lock a measurement reading on the display. Press the Hold button again to

unlock the display and obtain a real-time reading.

In PEAK mode, the meter displayed the PEAK value of AC Volts or Current measurement.

PEAK function is enabled by Depressing the PEAK HOLD button for > 2 seconds.

To Exit PEAK Mode Depress the PEAK HOLD button again for > 2 seconds.

The Max/Min records the maximum and minimum measured value. Press the Max/Min button

to activate this feature and to toggle between max, and Min readings. The unit will continually

capture max and min values over time. Depressing the max/min button for >2 sec. exits the

mode. Note: To record max/min values over a time period >30 min, the Auto Power Off (APO)

feature must be defeated.

Press “

∆” button to enter the Relative mode. The “∆” symbol is displayed, and the value on

the display is subtracted and stored as a reference value. In the Relative mode, the value shown

on the display is always the difference between the stored reference value and the present

reading. Press the “

∆” button again for > 2 seconds to exit the Relative mode.

The “ZERO” button is used to zero out the display before measuring DC current. Press the

“ZERO” button to subtract out the non-zero number. Then, measure the DC amps. Pressing the

“ZERO” button again causes the “ZERO” to flash and the original offset number to be displayed.

Depress the “ZERO” button for >2 sec. to exit this mode.

5

The meter automatically powers itself down after about 30 minutes of no use. Press any

button, and the meter will wake up and display the last reading taken before power down. 

To Disable APO, press and hold the ( / Hz) button while turning the dial to any desired

function. When APO is defeated, the “APO” will be removed from the display. Turning the meter

off and back on will restore the APO default.

Press the button in the middle of the meter to turn the back-

light on and off. The green backlight will remain lit for about 

3 minutes before it automatically turns off to conserve

battery power. 

Note: Backlight consumes 4x the battery power .

Backlight on in

all functions.