Insys Modem 56k 4.1 m/UL 11-02-01-01-40.022 Manuale Utente
Codici prodotto
11-02-01-01-40.022
Configuration
INSYS Modem 56k UL
18 Juni
05
4.9 Voice Mode and DTMF Transmission
The voice mode of the modem allows
•
to digitize telephone audio data and to transmit them over the serial line
•
to play back digitized audio data to the telephone line
•
to transmit and receive control signals as DTMF
4.9.1 DTMF Sounds
Keyboards of fixed network and mobile telephones produce DTMF sounds for the charac-
ters (0..9, A..D, *, #) as a combination of two frequencies which do not occur in the human
voice.
DTMF sounds are used for dialing in the telephone network. They may be used as well to
transmit control signals during a voice connection – e.g. for answering machines or
telebanking.
ters (0..9, A..D, *, #) as a combination of two frequencies which do not occur in the human
voice.
DTMF sounds are used for dialing in the telephone network. They may be used as well to
transmit control signals during a voice connection – e.g. for answering machines or
telebanking.
4.9.2 Remote Switching and Status Query
The latest firmware updates for INSYS Modem 144/336/56k 4.0 from January 2003 al-
low to set the control outputs and to query the status of the alarm inputs by DTMF sig-
nals. The INSYS Modem is ready to receive DTMF signals in incoming calls when the
DTMF mode has been activated. The connect is indicated by the OK signal and must be
answered by a 4 digit PIN. The PIN is acoustically acknowledged.
low to set the control outputs and to query the status of the alarm inputs by DTMF sig-
nals. The INSYS Modem is ready to receive DTMF signals in incoming calls when the
DTMF mode has been activated. The connect is indicated by the OK signal and must be
answered by a 4 digit PIN. The PIN is acoustically acknowledged.
The following commands are available for remote DTMF control by telephone keyboard:
Key Description
0*
Close connection
1*x
Control output 1:
x:
1
set control output 1 to 1
0
reset control output 1
Return: „OK“
2*x
Control output 2:
x:
1
set control output 2 to 1
0
reset control output 2
Return: „OK“
3*
Status query of both alarm inputs:
Status of both inputs is indicated in the form of HIGH (not active) or LOW (active).
Return: „OK“ – Status Input 1 – Status Input 2
The connection is closed by the INSYS Modem after a idle time of 25 seconds without
further DTMF signals.
further DTMF signals.