Insys Modem 56k small INT 2.0 11-02-01-01-43.003 Manuale Utente
Codici prodotto
11-02-01-01-43.003
INSYS Modem 56k small INT 2.0/USB 1.0
AT Command Set
June 06
45
9.1 Overview AT Commands
Command
Description
AT**
Start of the flash load function
ATA Answer
mode
The modem is switched into response mode. This is only effective in Germany, if the
connected phone goes off-hook or if a call comes in.
connected phone goes off-hook or if a call comes in.
A/
Repeat the last command
The last command is repeated.
AT\A<n>
Select maximum MNP block size
Define maximum block size for error corrected MNP transmissions.
AT\A0 64
byte
AT\A1 128
byte
(default)
AT\A2 192
byte
AT\A3 256
byte
AT*A<n>
Automatic call acceptance on/off
AT*A0
Call acceptance is blocked, irrespective of S0
AT*A1
Call acceptance according to S0 (default)
Note: see also S-Registry 36, bit 7
AT&A<n>
Selective Call Answer On or Off
To evaluate selective call answer, the phone number must be transmitted (CLIP). The
following countries support the “CLIP” function:
following countries support the “CLIP” function:
Australia, Belgium, China, Denmark, Germany, Finland, Great Britain, Hong Kong, In-
dia, Ireland, Iceland, Italy, Canada, Korea, New Zealand, The Netherlands, Norway,
Austria, Sweden, Singapore, Spain, Taiwan, USA.
dia, Ireland, Iceland, Italy, Canada, Korea, New Zealand, The Netherlands, Norway,
Austria, Sweden, Singapore, Spain, Taiwan, USA.
AT&A1
Switches the selective call answer ON
AT&A0
Switches the selective call answer OFF (default)
The AT&A setting is saved in AT&W.
AT%A<n>
Send alarm text manually
Manual triggering of the message. After the message is sent, the device responds with
OK (success) or ERROR (failure).
Note: see also AT*V<n>
OK (success) or ERROR (failure).
Note: see also AT*V<n>