Holzmann Maschinen H020300027 Scheda Tecnica
SAFETY
HOLZMANN MASCHINEN Austria www.holzmann-maschinen.at
Seite 22
MAGNETBOHRMASCHINE / MAGNETIC DRILL MBM 450LRE / MBM 600LRE
Hazard of electric shock
Undetected malfunctions in the power supply and/or the connected wood working machine
might result in electric shock when touching the machine. Ensure proper electric
installation, and let it check periodically by a trained electrician.
might result in electric shock when touching the machine. Ensure proper electric
installation, and let it check periodically by a trained electrician.
Danger due to unintended machine start-up
Eliminate this risk by disconnecting the machine before you perform any checks or
activities on the machine.
activities on the machine.
Hazard of inhaling toxic dust
Especially wood dust arising from chemically treated wood and/or lacquer/paint are
harmful when inhaled. Therefore wear a suitable breathing mask if required.
harmful when inhaled. Therefore wear a suitable breathing mask if required.
These risk factors can be minimized through obeying all security and operation instructions, proper
machine maintenance, proficient and appropriate operation by persons with technical knowledge and
experience.
11.6
Rules of assenbly
Know about the structure of the magnetic drill before use: electromagnetic suctorial cup,
spot drilling and the operational function of driving.
spot drilling and the operational function of driving.
Make sure that the switch is off and the plug is pulled out before installing or taking down
the aiguille.
the aiguille.
Rotate the handlweheel, check whether the electric drill can move up and down smoothly,
raise the electric drill to the top position(Side lay the backout.)
raise the electric drill to the top position(Side lay the backout.)
The aiguille must be sharp. As for Morse taper shand drill, please note the Tang must
insert into the drogue behind the gain when aiming at it. When disassembling the aiguille,
insert the wedge into the drogue gain, knock the hardhead to fall with a hammer.(The
aiguille must be sharp)
insert into the drogue behind the gain when aiming at it. When disassembling the aiguille,
insert the wedge into the drogue gain, knock the hardhead to fall with a hammer.(The
aiguille must be sharp)
After drill chuck clamps the aiguille, pick up the key wrench.
Put the power line behind the machine at work, keep it away from the aiguille.
The switches of the electric drill and the magnet must be set in the off position before
connecting to the power.
connecting to the power.
Fasten the safety belt when using the magnetic drill.