Mikroelektronika MikroE Development Kits MIKROE-1421 Scheda Tecnica

1. Introduction

Once you have soldered the headers your 
board is ready to be placed into desired 
mikroBUS™ socket. Make sure to align the 
cut in the lower-right part of the board 
with the markings on the silkscreen at the 
mikroBUS™ socket. If all of the pins are 

aligned correctly, push the board all 

the way into the socket.

3. Plugging the board in

2

3

2. Soldering the headers

1

4. Essential features

Turn the board upward again. Make sure 
to align the headers so that they are 
perpendicular to the board, then solder the 
pins carefully.

Turn the board upside down so that 
bottom side is facing you upwards. Place 
shorter parts of the header pins in both 
soldering pad locations.

Before using your click board™, make sure 
to solder 1x8 male headers to both left 
and right side of the board. Two 1x8 male 
headers are included with the board in 
the package.

click

BOARD

www.mikroe.com

FTDI click Manual

0 100000 023747

FTDI Click

™

 is an accessory board in 

™

 form factor. It’s a compact and 

easy solution for adding USB to UART/
SPI/I

2

C communication to your design. It 

features 

 dual high speed USB 

to multipurpose IC, DA converter as well 
as EEPROM. FTDI Click

™

 communicates 

with the target board microcontroller via 

™ 

SPI (MOSI, MISO, SCK, CS), 

I

2

C (SDA, SCL), UART (Tx, Rx), RST, PWM, 

AN and INT lines. LED diode (GREEN) 
indicates the presence of power supply.

FTDI 

click

FTDI Click™ with it’s 

 IC is a dual 

high speed USB 2.0 to UART/SPI/I2C serial 
interfaces converter. The entire USB protocol 
is handled on the chip (USB drivers from FTDI 
are required). The board can be powered 
by USB cable or directly from mikroBUS 
socket. It is ideal for USB applications (smart 
card readers, instrumentation, industrial 
control, MP3 player interface, digital camera 
interface, bar code readers) and many more.