Mikroelektronika MikroE Development Kits MIKROE-1421 Ficha De Dados
Códigos do produto
MIKROE-1421
1. Introduction
Once you have soldered the headers your
board is ready to be placed into desired
mikroBUS™ socket. Make sure to align the
cut in the lower-right part of the board
with the markings on the silkscreen at the
mikroBUS™ socket. If all of the pins are
board is ready to be placed into desired
mikroBUS™ socket. Make sure to align the
cut in the lower-right part of the board
with the markings on the silkscreen at the
mikroBUS™ socket. If all of the pins are
aligned correctly, push the board all
the way into the socket.
3. Plugging the board in
2
3
2. Soldering the headers
1
4. Essential features
Turn the board upward again. Make sure
to align the headers so that they are
perpendicular to the board, then solder the
pins carefully.
to align the headers so that they are
perpendicular to the board, then solder the
pins carefully.
Turn the board upside down so that
bottom side is facing you upwards. Place
shorter parts of the header pins in both
soldering pad locations.
bottom side is facing you upwards. Place
shorter parts of the header pins in both
soldering pad locations.
Before using your click board™, make sure
to solder 1x8 male headers to both left
and right side of the board. Two 1x8 male
headers are included with the board in
the package.
to solder 1x8 male headers to both left
and right side of the board. Two 1x8 male
headers are included with the board in
the package.
click
BOARD
www.mikroe.com
FTDI click Manual
ver. 1.01
0 100000 023747
FTDI Click
™
is an accessory board in
mikroBUS
™
form factor. It’s a compact and
easy solution for adding USB to UART/
SPI/I
SPI/I
2
C communication to your design. It
features
FT2232H
dual high speed USB
to multipurpose IC, DA converter as well
as EEPROM. FTDI Click
as EEPROM. FTDI Click
™
communicates
with the target board microcontroller via
mikroBUS
™
SPI (MOSI, MISO, SCK, CS),
I
2
C (SDA, SCL), UART (Tx, Rx), RST, PWM,
AN and INT lines. LED diode (GREEN)
indicates the presence of power supply.
indicates the presence of power supply.
FTDI
click
FTDI Click™ with it’s
FT2232H
IC is a dual
high speed USB 2.0 to UART/SPI/I2C serial
interfaces converter. The entire USB protocol
is handled on the chip (USB drivers from FTDI
are required). The board can be powered
by USB cable or directly from mikroBUS
socket. It is ideal for USB applications (smart
card readers, instrumentation, industrial
control, MP3 player interface, digital camera
interface, bar code readers) and many more.
interfaces converter. The entire USB protocol
is handled on the chip (USB drivers from FTDI
are required). The board can be powered
by USB cable or directly from mikroBUS
socket. It is ideal for USB applications (smart
card readers, instrumentation, industrial
control, MP3 player interface, digital camera
interface, bar code readers) and many more.