Conrad Energy remote control ARF 2185 mm ROC006 Scheda Tecnica

Spiralling is initiated with the aileron; the model angles to the side. If the model has reached the desired declination, 

the aileron is returned back into centre position. Now, the curve can be flown at a constant altitude by gently pulling 

the elevator control stick.
When the model is flying in the desired direction, a quick regulation of the aileron into the opposite direction will 

bring the model back to a horizontal position and also return the elevator to the centre position. Try not to take too 

narrow curves in the beginning and observe even flight height even in curves. 

 

The rudder efficiency depends on the deflection path at the transmitter, as well as the flight speed. If you 

do not take back the aileron in time after initiating a curve, the model will roll or turn onto its back. Practice 

controlling a roll only after having flown for a few hours.

 

When flying, always observe sufficient minimum flight speed. With the motor off, pulling on the elevator 

control lever too much will cause the model to slow down and tip forwards over the fuselage top or to the 

side over a wing. 

 

Therefore, fly at a sufficient safety height in the beginning in order to allow yourself to get used to the 

steering attitude of the model. Do not fly too far in order to be able to clearly evaluate flight attitude at all 

times.

If your model tends to drift to one direction in straight flight, correct the neutral position of the corresponding rudder 

by trimming at the transmitter. 
•  Rudder:
  If the model drifts or „pushes“ towards the left, push the rudder trim lever to the right until the model flies straight. If 

the model drifts towards the right, effect a trim correction towards the left. 

•  Elevator:
  Set the elevator trim lever so that the model rises at a flat angle at full motor speed and maintains the altitude with 

the motor off. If the model rises too much, push the trim forward. If the model tries to dip down with its tip all the 

time, push the trim backwards. 

•  Aileron:
  If the model turns to the left along the longitudinal axis, push the aileron trim lever to the right repeatedly until the 

model flies straight. If the model turns towards the right, effect a trim correction towards the left.

•  Wing flaps:
  The wing flaps can be used to increase the gliding performance, as support of the ailerons or as a landing aid in 

connection with the ailerons. With the wing flaps set neutrally, there is no change to the flight properties.