Renkforce DMX LED effect light No. of LEDs: 84 DL-LED163 DL-LED163 Scheda Tecnica

In this mode of operation, the light effect is used in automated or sound-to-light mode as a single device.
•  Set the desired operating mode according to the above table.
•  The DIP switches 5, 6, 7, 8 define the programme speed in automatic mode. The more DIP switches (4)

are in the position ON, the higher the programme speed.

•  In sound-to-light mode, the effect light reacts to music impulses that are recorded via the integrated

microphone MIC (5).

In this mode, several devices are connected to each other (see „Setting up a Master-Slave Chain“). One

device (the master device) controls the connected devices (slave devices) synchronously through its in-

tegrated controller.
•  Set the desired operating mode at the master unit with the DIP switches (4) (see above).
•  On the slave devices, set all DIP switches to OFF to define them as slave devices.
•  Set the DIP-switch 9 at the slave devices to ON to define them as slave devices that react opposite to the

master device (inverted slave mode).

 No external DMX controller must be connected to the master device in this mode of operation.

Only one device in a master-slave-chain must be defined as master device. All other devices

must be defined as slave devices.

In this operating mode, the effect light is controlled by the external DMX controller.
Set the DMX starting address with the DIP switches 1-9.

 Each DMX device in a DMX chain requires a so-called start address to be clearly identified and

controlled by the DMX controller.

This starting address is defined by the DIP switches 1-9. Each DIP switch is assigned a value. The

total of these values then defines the starting address. The starting address determines the first

DMX channel; the second DMX channel is the channel following the starting address, etc.

DIP switches  1

2

3

4

5

6

7

8

9

Value

1

2

4

8

16

32

64

128  256

Example:
DIP switches 1, 3 and 5 are set to „ON“, all other switches are set to „OFF“
Starting address = 1 + 4 + 16 = 21

 The device requires 6 DMX channels.