Siemens SPS starter kit 6ED1057-3BA00-0AA8 12 Vdc, 24 Vdc 6ED1057-3BA00-0AA8 Scheda Tecnica
Codici prodotto
6ED1057-3BA00-0AA8
Reference material
5.3 Special functions
LOGO!Soft Comfort Online Help
266
Operating Instructions, 06/2014
Output Q
Q is set/reset, depending on the stored analog value and the offset.
* AI1 to AI8: 0 to 10 V corresponds with 0 to 1000 (internal value).
Parameters Threshold 1 and Threshold 2
The two threshold parameters Threshold 1 and Threshold 2 can be provided by the actual
value of another already-programmed function:
● Analog comparator: Ax - Ay
● Analog threshold trigger: Ax
● Analog amplifier: Ax
● Analog multiplexer: AQ
● Analog ramp: AQ
● Mathematic instruction: AQ
● PI controller: AQ
● Up/Down counter: Cnt
For the 0BA7 and 0BA8 devices, you can additionally use the actual values of the following
● Analog comparator: Ax - Ay
● Analog threshold trigger: Ax
● Analog amplifier: Ax
● Analog multiplexer: AQ
● Analog ramp: AQ
● Mathematic instruction: AQ
● PI controller: AQ
● Up/Down counter: Cnt
For the 0BA7 and 0BA8 devices, you can additionally use the actual values of the following
already-programmed functions:
● On-delay: Ta
● Off-delay: Ta
● On-/off-delay: Ta
● Retentive on-delay: Ta
● Wiping relay(pulse output): Ta
● Edge triggered wiping relay: Ta
● Asynchronous pulse generator: Ta
● Stairway light switch: Ta
● Multiple function switch: Ta
● Stopwatch: AQ
● Analog filter: AQ
● Average value: AQ
● Max/Min: AQ
● Threshold trigger: Fre
You select the required function by the block number.
The thresholds are represented by the symbol Δ on the LOGO! Base Module and in the
● On-delay: Ta
● Off-delay: Ta
● On-/off-delay: Ta
● Retentive on-delay: Ta
● Wiping relay(pulse output): Ta
● Edge triggered wiping relay: Ta
● Asynchronous pulse generator: Ta
● Stairway light switch: Ta
● Multiple function switch: Ta
● Stopwatch: AQ
● Analog filter: AQ
● Average value: AQ
● Max/Min: AQ
● Threshold trigger: Fre
You select the required function by the block number.
The thresholds are represented by the symbol Δ on the LOGO! Base Module and in the
timing diagram below.
0BA4:
Gain: Range of values: 0.00 to 10.00
Gain: Range of values: 0.00 to 10.00