Buffalo NAS server 8 TB TeraStation 1400 TS1400D0804-EU TS1400D0804-EU Scheda Tecnica

75

Notes: 
•  The USB memory device should have a capacity of at least 1 GB.
•  Any data stored on the USB memory device will be deleted.

In Settings, click Management

Click 

 to the right of "Restore/Erase".

From "Target USB drive", select the USB memory device that is connected to the USB 2.0 port of the 
TeraStation.

Select "Save current configuration to a USB drive". Click Execute.

The "Confirm Operation" screen will open. Enter the confirmation number, then click OK.

When the following message is displayed, saving settings is finished. Click OK.

If the settings are not saved to the USB memory device successfully, you may receive the error message "The 
specified operation cannot be executed". Verify:
•  The device has a capacity of 1 GB or larger.
•  The device is not write-protected.

Note: If you changed any hostname or network settings since your last backup, save your settings again to the 
USB memory device again.

The saved settings can be applied to a different TeraStation (of the same series). There are two ways to apply settings 
from the USB memory device.

Connect the USB memory device with the saved settings to a USB 2.0 port (not a USB 3.0 port) of the 
TeraStation.

In Settings, click Management.