Buffalo NAS server 8 TB TeraStation 1400 TS1400D0804-EU TS1400D0804-EU Scheda Tecnica

76

Click 

 to the right of "Restore/Erase".

From "Target USB drive", select the USB memory device that is connected to the USB 2.0 port of the 
TeraStation.

Select "Transfer settings from a USB drive", then click Execute.

The "Confirm Operation" screen will open. Enter the confirmation number, then click OK.

Note: Do not press the function button while applying settings from the USB memory device.

When the following message is displayed, applying settings is finished. Click OK.

Turn off the TeraStation.

Insert the USB memory device with the saved settings into a USB 2.0 port (not a USB 3.0 port) on the 
TeraStation.

While holding down the init button on the back of the TeraStation, press the power button.

Hold down the init button until the function LED starts blinking red. When it starts to blink, let go of the 
button.

When the TeraStation is ready, the power LED will start blinking red and the I41 message will be displayed in 
NAS Navigator2.

Hold down the function button until the TeraStation beeps. Applying settings will start.

It will take several minutes for the settings to apply, When finished, the TeraStation will shut down.

Remove the USB memory device, then power on the TeraStation.

There are two ways to initialize the TeraStation. To initialize the TeraStation to its factory default settings, follow one 
of the procedures below.