DeLonghi DMX 664 V Scheda Tecnica

15

•  After turning the appliance on as described

above,  wait  for  the  “iron  at  temperature”

light O to go off.

•  To discharge steam, press the steam button

L  on  top  of  and  under  the  handgrip  of  the

iron.  

•  To discharge steam continuously, move the

continuous steam lock M forwards.

•  The iron can be rested in an upright position

(fig. 1). However, make sure the surface is

flat to avoid the iron falling over.

•  After turning the appliance on as described

above,  wait  for  the  “iron  at  temperature”

light O to go off.

•  To discharge steam, press the steam button

L  on  top  of  and  under  the  handgrip  of  the

iron. 

•  To discharge steam continuously, press the

continuous steam lock M to block the button

mechanically.

•  The iron can be rested in an upright position.

Make sure the surface is flat to avoid the iron

falling over accidentally. To rest the iron cor-

rectly, fix the steam/cable tube on the right

or left (figs. 2 and 3) by pushing it as far as

it will go until it clicks into place. 

•  (Some models only) Safe transport: the iron 

has a locking system to avoid it being acci-

dentally  dropped  during  transport  or  when 

stored after use.  

To lock the iron in position, insert the tip in

the housing on the iron rest and press the 

iron downwards until it clicks into place (fig.

4).  

To release the iron, press the

button

P  and  remove  the  iron.  While  ironing,  rest

the iron as shown in fig. 10 (without locking

in place). 

Never  move  or  lift  the  appliance

using the iron as a carrying handle. 

Turn the thermostat knob to set the

most  suitable  temperature  for  the

type of fabric to be ironed.

For steam ironing, the temperature must be wi-

thin the steam sector shown alongside. 

Below  is  a  brief  guide  to  help  you  choose  the

best temperature for the type of fabric to be iro-

ned. 
l

Acetate, acrylic, nylon, polyester, rayon

l l  

Silk, wool

l l

 l Linen, cotton

The steam regulation knob H enables the quanti-

ty of steam to be increased or decreased accor-

ding to the fabric being ironed.

When you turn the iron on, you are recommen-

ded to turn the steam regulation knob to the ma-

ximum steam position.

The corresponding light comes on. 

Topping up the tank with water
When the water runs out, the

 light goes off. 

When the light goes off, you must top up the wa-

ter in the tank as rapidly as possible, following

the procedure for filling the tank.

This enables you to continue ironing without in-

terruption. 

If you delay topping up the water and the ste-

am generator cools down, the system no longer

emits steam and when the tank has been filled

again, the appliance functions as though turned

on for the first time.

In other words, 5 minutes will elapse before the

steam is ready and during those 5 minutes you 

will hear the pump fill 4 or 5 times for about 30

seconds.  

After this period of stabilisation, the steam ge-

nerator will start working normally, periodically

filling with water.

When the “no water” light goes off, you should

not  continue  steam  ironing  with  the  pump  vi-

brating. If this practice is continued, in the long

run it could irreparably damage internal compo-

nents.