Renkforce LED outdoor wall light 6 W Warm white 2661LED Anthracite 2661LED Scheda Tecnica

 

•   The  outdoor  LED  wall  lamp  may  be  operated  only  on  the  mains  volt-

age (see section “Technical Data”). Never try to operate the product at  

another voltage, as this will cause its destruction.

 

•   The outdoor LED wall lamp is designed according to Protection Class I; the 

protective earth conductor must be connected. 

 

   If mains supply with a protective earth conductor is not available at the 

place of installation, the outdoor LED wall lamp must not be connected/

used there. In this case, install a new mains supply with a protective earth 

conductor.

 

   During installation, all poles must be disconnected from the mains voltage 

via a cut-off device (e.g., an RCD).

 

•   The  outdoor  LED  wall  lamp  may  be  installed  and  operated  indoors  and 

outdoors. However, never install it in water.

 

•   The outdoor LED wall lamp may not be operated using a dimmer.

 

•   Do not mount or use the outdoor LED wall lamp in rooms, or under adverse 

environmental conditions, where combustible gases, vapours or dust are 

or may be present! There is a risk of explosion!

 

•   Use  the  outdoor  LED  wall  lamp  only  when  it  is  permanently  installed.  

Never install the outdoor LED wall lamp in vehicles.

 

•   Do not install or attach objects (e.g. decorative material) to the outdoor 

LED wall lamp.

 

•   Caution, LED light: Do not look directly into the LED light! Do not look into 

the beam directly or with optical instruments!

 

•   The outdoor LED wall lamp must not be exposed to extremes of tempera-

ture, strong vibrations or heavy mechanical stress.

 

•   If you have reason to assume that safe operation is no longer possible, 

disconnect the outdoor LED wall lamp immediately and secure it against 

inadvertent operation. After this, arrange for an expert to check the out-

door LED wall lamp.

 

   Safe operation can no longer be assumed if:

 

  -  the outdoor LED wall lamp has visible damage

 

  -   the outdoor LED wall lamp does not work at all or works poorly (where 

there is flickering light, leaking smoke or a burning smell, audible crack-

ling noises, or discolouration to the product or to adjacent surfaces)

 

  -   the outdoor LED wall lamp was stored under unfavourable conditions

 

  -  it was exposed to heavy loads during transport

 

•   Do not leave packaging material carelessly lying around, since it could 

become a dangerous plaything for children.

 

•   In commercial institutions, the accident prevention regulations of the Em-

ployer’s Liability Insurance Association for Electrical Systems and Operat-

ing Facilities are to be observed.

 

•   If you have any questions that are not answered in this manual, please 

contact our technical department or another specialist.

  Please consult the chapter “Safety Instructions”!

•   Install the outdoor LED wall lamp only on a stable surface. Use screws and plugs 

that are suitable for the surface. Use the outdoor LED wall lamp only when it is per-

manently installed.

•  The LED outdoor wall light must be installed and used out of the reach of children.
•   The outdoor LED wall lamp must be protected on the distribution board by a 10/16 A  

fuse. An earth fault circuit interrupter must be installed before this (FI protective 

switch).

•  The outdoor LED wall lamp must be voltage-free during installation. It is not suf-

ficient to just turn off the light switch.

  Turn the power off and ensure that none of the poles is live by removing the electric 

circuit’s fuse or switching off at the circuit breaker. Then, switch off the associated 

earth fault circuit interrupter (breaker). Secure it against unauthorised reconnec-

tion, e.g., with a danger sign. 

•  Check that the mains cable is free of current, e.g., with an appropriate tester. 

G   Operating Instructions

The outdoor LED wall lamp can be used to illuminate indoor and outdoor areas. The 

product is intended for installation on a wall. 
Always observe the safety instructions and all other information included in these op-

erating instructions!
Any use other than that described above could lead to damage to this product and 

involves the risk of short circuits, fire, electric shock, etc. No part of the product may 

be modified or converted!
This product complies with the applicable national and European requirements. All 

names of companies and products are the trademarks of the respective owners. All 

rights reserved.

•  LED outdoor wall lamp
•  Installation accessories (4 screws, 4 wall screw-plugs, 4 rubber washers)
•  Allen key
•  Operating instructions

   The lightning symbol inside a triangle is a warning to inform you of potential 

risks of personal injury, such as electrical shock.

   This symbol indicates specific risks associated with handling, function and 

use. 

  The “arrow” symbol indicates special tips and operating information.

  The light cannot be dimmed.

  Observe the operating instructions!

 

•   Unauthorised  conversion  and/or  modification  of  the  product  is  not  

allowed for safety and approval reasons (CE).

 

•   The outdoor LED wall lamp is not a toy and should be kept out of the reach 

of children! There is danger of a life-threatening electric shock! Install the 

outdoor LED wall lamp in such a way that it cannot be reached by children.