Buffalo TeraStation 5400R 8TB WS5400R0804 Scheda Tecnica

139

Timer 3: Not used
On days other than Wednesday, normal operation begins at 9:00 and the unit goes into sleep mode at 18:00. On 
Wednesday, normal operation begins at 7:30 and the unit goes into sleep mode at 22:00.

•  To wake the TeraStation from sleep mode manually, press the power button.

The TeraStation supports Wake-on-LAN, which allows it to be turned on remotely.

In Settings, click Network.

Click the 

 icon to the right of “IP Address”.

Click Change.

Enable “Wake-on-LAN”, then click OK.

Wake-on-LAN is now enabled. As long as it is connected to power and the network, you can turn on the 
TeraStation remotely.

Notes: 
•  After a power outage, wait 5 minutes after power is restored to send the Wake-on-LAN packet to the TeraStation.
•  After receiving the Wake-on-LAN packet, the TeraStation may take approximately five minutes to be ready to use.
•  To use Wake-on-LAN, you’ll need Wake-on-LAN software such as AMD’s Magic Packet utility. The TeraStation does 

not include Wake-on-LAN software.

•  The TeraStation does not support using Wake-on-LAN and port trunking at the same time. You may use either 

feature, but not both at the same time.

•  On the local network, Wake-on-LAN packets may be sent to port 2304 on either of the TeraStation’s LAN ports. If 

the TeraStation is connected to a Buffalo wireless router configured for remote access, then it may be turned on 
from outside the local network (from the WAN side). To use this feature, connect the router to only LAN port 1 on 
the TeraStation.

If a UPS (sold separately) is attached, the TeraStation can be automatically shut down for protecting data in the event of