Jeti Hendheld RC 2.4 GHz No. of channels: 8 80001585 Manuale Utente
Codici prodotto
80001585
computer radio control system
EN
4.4.6 Transmitter Mode Switch
The DS-16 transmitter allows you to switch between Mode 1, 2,
3 and 4 stick configurations with just few simple steps. In order to do
some of these, the stick control assemblies will need to be swapped.
3 and 4 stick configurations with just few simple steps. In order to do
some of these, the stick control assemblies will need to be swapped.
1.
Switch off the transmitter and remove the screws that secure
the radio back cover. Next, remove the radio back cover.
Be sure to disconnect the transmitter battery pack.
2.
Release and pull out the screws of the upper printed circuit
board (the "T" plate).
3.
Remove the "T" circuit board by grasping the plate by its edges
near where the bottom fastener goes. Gently lift the board to
disconnect its connectors from the board below. Once
disconnected, tilt the board upward toward the display so that
it is out of the way.
4.
Disconnect the control stick assembly wires from the Tx board.
(3 wires
).
X, Y , S
5.
Remove the stick assembly connecting wires from their holders
on the main board.
6.
Remove both machine installation screws for each of the
control stick assemblies.
7.
Carefully remove both installation machine screws. Gently lift
in your direction (toward the transmitter back side).
8.
Swap both stick assembly units an install them back into their
correct positions.
2.
2.
2
3
XX
YY
SS
SS
YY
XX
XX
YY
SS
4
5
6
7
8
33