Jeti Hendheld RC 2.4 GHz No. of channels: 8 80001585 Manuale Utente
Codici prodotto
80001585
computer radio control system
EN
9.
Reinstall and secure the machine screws for each of the control
stick assemblies.
10.
Connect the control stick assembly wires to the Tx board
connector (3 wires
. The orientation of the wires is
X, Y , S
)
labeled on the board.
11.
Secure the stick assembly wires into their holders.
12.
Mount the "T" plate back into place. First insert the connectors
of the "T" printed circuit board into the body of transmitter and
then carefully insert the "T" plate into its connectors on the
main board. Be careful while handling the wires underneath the
"T" plate to avoid any resistance when installing the "T" plate. If
the wires cause any resistance or if the wires are pinched or
stressed in any way, please re-route the wires and try the "T"
board installation again.
13.
Reinstall the "T" plate mounting screws.
14.
Reconnect transmitter battery pack and reinstall radio back
cover and cover screws.
After making a mode switch you must re-calibrate the
transmitter stick assemblies and setup the correct mode
in the software menu, see section 9.6.1 – Configuration.
The switch between Modes 1 to 3 or Modes 2 to 4 are
done with the software only (NO manual stick change is
necessary).
transmitter stick assemblies and setup the correct mode
in the software menu, see section 9.6.1 – Configuration.
The switch between Modes 1 to 3 or Modes 2 to 4 are
done with the software only (NO manual stick change is
necessary).
Note:
2.
2.
4.4.7 Transmitter Gimbals with Switch or Button
Installation
If you want to operate the DS-16 transmitter using the optional stick
end switch or button functions, you must purchase one or more of
these separately:
end switch or button functions, you must purchase one or more of
these separately:
•
Stick with 2-position switch
•
Stick with 3-position switch
•
Stick with push-button
•
Stick with potenciometer
For installation of the optional gimbal stick ends with
switches/buttons we recommend that you send your
transmitter to one of the factory authorized service
centers or to your authorized dealer.
switches/buttons we recommend that you send your
transmitter to one of the factory authorized service
centers or to your authorized dealer.
Advice:
1.
Switch off the transmitter and remove the 8 screws that secure
the radio back cover. Next, remove the radio back cover. Be sure
to disconnect the transmitter battery pack connector .
2.
Release and pull out the screws of the upper printed circuit
board (the "T" plate).
3.
Remove the "T" circuit board by grasping the plate by its edges
near where the bottom fastener goes. Gently lift the board to
disconnect its connectors from the board below. Once
disconnected, tilt the board upward toward the display so that
it is out of the way.
4.
Disconnect the control stick assembly wires from the Tx board.
(3 wires
).
X, Y, S
5.
Remove the stick assembly connecting wires from their holders
on the main board.
34