Renkforce 808576 Wireless Surveillance System 808576 Scheda Tecnica

Briefly push the button „ “ on the screen/DVR or the IR remote control to switch the screen/DVR on or 

off.  

  The radio cameras cannot be switched on or off. They work permanently if the power is connec-

ted.

Briefly push the button „MENU“ on the radio camera or the IR remote control. Then the main menu is 

displayed.
To leave the OSD menu, also briefly push the button „MENU“ (several times if required, if the screen/DVR 

is in a submenu.

Use the button „AV“ on the screen/DVR or the IR-remote control to switch between playback of the AV-

signal on the screen/DVR and the AV-output.

  If the AV-output is activated, the screen/DVR display goes out.

As a special feature, the small housing (19) in the radio camera‘s cable holds a microphone. The radio

camera therefore not only shows the image of the monitored area, but also permits hearing monitored 

sound. 
The playback volume at the screen/DVR can be set at the screen/DVR or via the IR remote control:
„8“ button = increase volume
„2“ button = reduce volume
At the bottom left of the display, a small speaker icon with the currently set volume level appears when the 

button is pushed. this display goes out again after a few seconds.

  If the radio camera is operated too close to the screen/DVR (e.g. for testing at initial commissi-

oning or when logging the radio camera on to the screen/DVR), there may be a feedback and 

whistling sound. Then reduce the volume as described above.

 

The volume cannot be set in zoom mode, since the arrows are used to move the visible section of 

the screen here. If required, briefly switch to the quad or auto mode (see chapter 10 e) by pushing 

the button „

“ and then set the volume as desired.