Brother HL-1112 HL-1112E Scheda Tecnica

General Information 

If there is an error that cannot be cleared by the user, the machine will show that a service call is needed by 
lighting up all the LEDs as shown below.

 

If you see the service call indication shown above, turn off the machine, and then turn it back on and try to 
print again.

If the error is not cleared after turning the machine off and then back on, press 

. The LEDs will light up 

as shown in the following table to identify the error. The number under the LED icon shows how many times 
the LED will blink.

1

If this error occurs, turn off the machine, wait a few seconds, and then turn it on again. Leave the machine for approx. 15 minutes with the power 
on. If the error occurs again, call Brother customer service or your local Brother dealer.

For example, the LED indication below shows a fuser unit failure.

 

Make a note of the indication, referring to LED error indication on page 41, and report the error status to 
Brother customer service or your local Brother dealer.

Make sure that the top cover is completely closed before you report a service call.

 

 

 

 

 

 

 

 

(7)/(4)

 

(3)

 

(5)

 

(6)

 

(2)

 

(1)

0.5 sec.

0.5 sec.

0.5 sec.

1 sec.