Bunn VLPFCanada Manuale Proprietario

Page 22                                    

If continuity is not present as described, replace the 

switch.

Removal and Replacement:

1.  Remove all wires from the switch terminals.

2.  Compress  the  clips  inside  the  hood  and  gently 

push the switch through the opening.

3.  Push the new switch into the opening and spread 

the clips to hold the switch captive in the panel.

4.  Refer to FIG. 15 when reconnecting the wires.

FIG. 15 ON/LEFT SWITCH TERMINALS

WHI to Right switch

WHI to Left warmer

BLK to Right switch

BLK to Cordset

WHI/RED to Start switch

WHI/VIO to Left warmer

P1987

Location:

 

The On/Left switch is located in the front of the 

hood, above and to the left of the brew funnel.

Test Procedure:

1.  Disconnect the brewer from the power source and 

remove the wires from all three terminals of the 

On/Left switch.

2.  With  a  voltmeter,  check  the  voltage  across  the 

black and white wires. Connect the brewer to the 

power source. The indication must be 120 volts 

ac.

3.  Disconnect the brewer from the power source.

If voltage is present as described, proceed to #4.

If voltage is not present as described, refer to the Wir-

ing Diagram and check the brewer wiring harness.

4.  Check for continuity across the two terminals on 

the left side of the switch when it is in the upper 

position. Continuity must not be present across 

these terminals in the lower position.

If continuity is present as described, reconnect the 

wires, the switch is operating properly.

P2172.80

FIG. 14 ON/LEFT SWITCH

10179 060100