Braun NL MILLENIUM 5 Manuale Utente

Page 6

Wedges

Angle A 

equals 

Angle B.

✓

Approximately 

1” Clearance

Inboard

Outboard

Inboard

Outboard

Wedges

Toe must 

angle 

down 

slightly.

Barrier 

must 

unfold 

fully.

Adjusting the platform angle based on the 
relationship of the platform at ground level 
directly affects the angle of the platform 
when positioned at floor level.    

Unfold the lift and visually examine the 
angle of the platform when positioned at 
floor level.  Lower the platform fully and 
note the angle of the platform when it 
reaches ground level also.  The outboard 
end of the platform (toe) must contact 
the ground first when the platform is 
lowered (all lift models).

The platform angle should be adjusted so 
there is a balance between the angle at 
both positions (equal amount of angle).  
Angle A should equal angle B as shown 
in Figure C.

The platform angle must be adjusted so 
the outboard end of the platform (toe) is 
angled down slightly when positioned at 
floor level.  See Figure D.  The outboard 
end of the platform must contact the 
ground first to ensure the spring-loaded 
outer barrier unfolds fully.

Adjustment Procedures:  Adjustment 
Allen screws are provided on each side of 
the lift platform for adjusting the platform 
angle.  Details and photos are provided 
on the opposite page.

Base Plate Wedges:  Installations where 
base plate wedges are used require more 
platform angle adjustment than normal.

Platform Stop Blocks:  When ad-
justing platform angle, ensure both 
stop blocks are making full contact 
with the vertical arms (details on 
opposite page).  

Floor Level Adjustment:  Follow-
ing platform angle adjustment, set 
floor level positioning as detailed in 
Platform Floor Level Adjustment 
(details on page 8).