Bosch DKE94 Manuale Utente

English 4

of weight the wall must support. Note: At least one screw must be installed 
through a stud.

Electrical Specifications: 120V AC, 60Hz. 15A Branch Circuit

 To avoid electrical shock hazard, before installing, 

switch power off at the service panel and lock the panel to prevent the 
power from being switched on accidentally.

Pull hood from outer packaging. Remove and discard all packaging materials. 
Remove filter and set aside (See Use and Care manual for removal instructions).

Install one-way damper so that the flap opens up. Press damper down into the 
blower outlet until it is snug. Note: verify that the flap opens up (toward the ceiling) 
before continuing. See “Prepare Ductwork” on page 4. If necessary, install transi-
tion, thermal break and additional backdraft damper.

See “General Information” on page 2 for recommended installation height and 
“Mounting Requirements” on page 3 for information on wall requirements.

Once the preferred height is determined, draw a line at the vertical centerline of 
the cooking appliance.

Use the installation template to locate and mark the screw holes. Drill 1/4” (6 mm) 
pilot holes (4 holes for hood screws and 2 holes for chimney screws). Install plugs 
in screw holes so that they are flush with the wall.Install two screws in top hood 
screw holes. Leave about 3/8” (6 mm) of each screw exposed.

30” (760 mm)

140 lbs (63.5 kg) 

126 lbs (57.1 kg)

36” (900 mm)

155.5 lbs (70.5 kg) 

142 lbs (64.5 kg)

 Figure 2: Prepare Ductwork