Brother FAX 2600 Manuale Utente

      R E M O T E   F A X   O P T I O N S

Follow the commands below to access features remotely. When you call the 
FAX/MFC and enter your Remote Retrieval Access Code (1 5 9   ), the system 
will signal you with two short beeps to enter a remote command.

1  OFF

If you hear one long beep, the change is 
accepted. If you hear three short beeps, you 
cannot change it because the conditions  have not 
been met (Example: registering paging number). 
You can register your fax forwarding number by 
using 4. FAX FWD NO (see p. 8-1). Once you 
have registered the number, the FAX/MFC will 
change automatically to FAXFWD:ON mode. 
Then retrieve a Memory Status List by entering 
961 (see p. 8-5) to make sure that the Fax 
Forwarding number you registered is correct in 
the List.

2  Fax Forwarding

3  Paging

4  FAX FWD No.

6  Fax Storage ON

7  Fax Storage OFF

You can set FAX STORAGE to ON or OFF.

1  Memory Status List

Enter the number of a remote fax machine to 
receive the Memory Status List or stored fax 
message(s). (See p. 8-5)

2  Retrieve all faxes

3  Erase fax from the  

memory

If you hear one long beep, you can erase fax 
message(s) from the memory.

1  FAX

You can check whether your FAX/MFC has 
received any faxes. If yes, you will hear one long 
beep. If no, you will hear three short beeps.

1  TAD

If you hear one long beep, you can change the 
Receive Mode. If you hear three short beeps, you 
cannot change it.

2  FAX/TEL

3  FAX

After a long beep, you can exit remote access.