Razor Bicycle Accessories 25143060 Manuale Utente

7

Product does not run

Product suddenly 

stopped working while 

in use

Short run time (less than  

15 minutes per charge)

Product runs sluggishly

Sometimes the product 

doesn’t run, but other 

times it does

Product makes loud 

noises or grinding 

sounds

Product is rolling backwards

Undercharged battery

Loose wires or connectors

Burned-out fuse

Motor or electrical switch damage

Undercharged battery

Brakes are not adjusted properly

Riding conditions are too stressful

Tires are not properly inflated

Product is overloaded

Loose wires or connectors

Motor or electrical switch damage

Chain is too dry

Throttle will not engage if the product is rolling backwards. Come to a 

complete stop and then activate the throttle.

Charge the battery. A new battery should have been charged for at 

least 12 hours before using the product for the first time and up to 12 

hours after each subsequent use.

Check all connectors. Make sure the charger connector is tightly 

plugged into the charging port, and that the charger is plugged into 

the wall.

Check all wires and connectors to make sure they are tight.

The fuse will burn out and automatically shut off the power if the 

motor is overloaded. 

An excessive overload, such as too heavy a rider or too steep a 

hill, could cause the motor to overheat. Refer to replacing the fuse 

instructions on page 5 of this manual. Correct the conditions that 

caused the fuse to burn out and avoid repeatedly burning out fuse.

Contact your local Razor authorized service center for diagnosis and 

repair.

Charge the battery. A new battery should have been charged for at 

least 12 hours before using the product for the first time and up to 12 

hours after each subsequent use.

 

Check all wires and connectors. Make sure the battery connector is 

tightly plugged into the charger connector, and that the charger is 

plugged into the wall.

Refer to brake adjustment instructions on page 4 of this manual.

Use only on solid, flat clean and dry surfaces such as pavement or 

level ground.

The tires are inflated when shipped, but they invariably will lose some 

pressure between the point of manufacturing and your purchase. Refer 

to instructions on page 4 of this manual to properly inflate tires.

Make sure you do not overload the product by allowing more than one 

rider at one time, exceeding the maximum weight limit, going up too 

steep a hill or towing objects behind the product. 

Check all wires around the motors and all connectors to make sure 

they are tight.

Contact your local Razor authorized service center for diagnosis and 

repair.

Apply a lubricant such as 3 in 1

TM

 or Tri-Flow

TM

 to the chain.