Yaesu FT-450D Manuale Utente

Page 88

FT-450D O

PERATION

 M

ANUAL

C

LONING

You can transfer all data stored in one transceiver to another set by utilizing the handy “Cloning” feature. This
requires a user supplied cloning cable, which connects the CAT jacks on the two transceivers, as shown below.
To clone from one transceiver to another, use the following procedure:

1. Insert the D-SUB 9pin cross cable (User Supplied)

into the CAT jack of each transceiver.

2. Turn both transceivers off, then press and hold in

the [MODE

] and [MODE] buttons on each ra-

dio while turning the power on again. The “cLonE
C.S-SND

” notation will appear on the display.

3. On the “Source” radio, press the [C.S/VOICE] but-

ton.

4. Data will now be transferred to the “Destination”

radio from the “Source” radio.
When the clone completes successfully, “CLonE
SENDING

” is displayed on the display.

If there is a problem during the cloning process,
“Error” will be displayed. Check your cable con-
nections and try again.

5. If cloning is successful, turn the “Destination” ra-

dio off, and “cLonE C.S-SND” notation will reappear
on the “Source” radio.

6. Turn the “Source” radio off.
7. Remove the clone cable. The channel and oper-

ating data for both radios are now identical. Both
radios may be turned on now for normal opera-
tion.

N

OTE

:

The cloning operation cannot be performed between
the FT-450D and FT-450.

INPUT

DC 13.8V

       22A

ANT

GND

EXT

SPKR

CAT

LINEAR

TUNER

DATA

INPUT

DC 13.8V

       22A

ANT

GND

EXT

SPKR

CAT

LINEAR

TUNER

DATA

D-SUB 9pin cross cable (User Supplied)

[C.S/VOICE] button

“Destination”

“Source”

Press the [C.S/VOICE] button

[MODE

] and [MODE] buttons

[ON/OFF] button