Viking Huskylock 936 Manuale Utente
1.5~2.0mm
5cm
—62—
Finish
Shirring
D
C
B
Stitch selection
E
A
Cording and Piping (Cording) (Option)
(Included in optional Huskylock 936 Cover
Stitch Kit, Part number: 412 6716-01)
Cording
1. Press the stitch selection button until “Auto N”
“Cover stitch narrow” appears. (Illus. A)
2. Press the fabric selection button until appro-
priate fabric type appears.
Note: Use needle B & E.
3. Raise the presser foot and snap on Cording
and Piping foot.
4. Snap cord guide into hole on front of needle
plate.
5. Insert cord into the hole of the cord guide,
then traverse through groove of the cording
and piping foot.
Note: 1/8”-1/4” (1.5~2.0 mm) cord can be
used.
6. Pull the cord tail about 2” (5 cm) behind the
foot. (Illus. C)
7. lnsert fabric between the foot and cord. Slide
fabric under foot and up to needles. (Illus. D)
8. Lower presser foot and sew.
Note: Hold cord behind foot when beginning
to sew.
9. Shirring with elastic cord: Thread elastic cord
through cord guide and under foot, same as for
cording. Slide fabric between elastic cord and
fabric, up to needles. Sew over elastic cord. Pull
both ends of elastic to draw up. (Illus. E)
Needle plate
Cord Guide
Cording and
Piping Foot
Piping Foot
Cord Guide