Sterling Doll BF3-600 Manuale Utente

Digital Dosing Units 

12

be exposed to extreme heat (maximum temperature 45

°C or 115°F) or excessive 

moisture. 

4.  Electrical connection to process machine: 

•  Injection Molding: Connect the cycle/run slave cable (thin two-conductor cable) 

to a set of DRY (NO VOLTAGE) contacts that CLOSE for the duration of screw 

recovery.  See Figure 5, electrical diagram. 

 
 
 
 
 

 

 

        J12-3 

 
 
 

 

 

        J12-2 

 
 

 

 

 

 Relay 

contact 

      

Injection molding 

 

Digital Dosing controller  

 Machine 
 
 

 

•  Extrusion-Constant: Wire the cycle/run slave cable (thin two- conductor cable) to a 

set of DRY (NO VOLTAGE) contacts that CLOSE when the screw rotates. See 

Figure 6 for electrical diagram.   

•  Extrusion-Proportional:  Wire the cycle/run slave cable to the extruder signal 

output that is proportional to the extruder speed.  The signal output can be one of the 

following: 0-10VDC or 0-20mA.  Please refer to the labels on the cycle/run slave 

cable for the correct input to avoid damaging the controller.  Digital Dosing 

Additive Feeder is configured from the factory for each specific input.  See Figure 5 

for the electrical diagram for voltage inputs.  See Figure 6 for frequency inputs.