Ryobi 5-Speed Power P206 Manuale Utente

12

Fig. 10

See Figure 8.
The magnetic tray conveniently stores screws or other small 
parts.

See Figure 9 - 10.


  Lock the switch trigger by placing the direction of rotation 

selector in the center position.



  Open or close the chuck jaws to a point where the open-

ing is slightly larger than the bit size you intend to use. 
Also, raise the front of the drill slightly to keep the bit from 
falling out of the chuck jaws.



Insert the drill bit.



Tighten the chuck jaws on the drill bit.

Make sure to insert the drill bit straight into the chuck 
jaws. Do not insert the drill bit into the chuck jaws at 
an angle then tighten, as shown in figure 10. This could 
cause the drill bit to be thrown from the drill, resulting 
in possible serious personal injury or damage to the 
chuck.



Rotate the chuck clockwise to tighten the chuck jaws 
securely on the bit. 

 

NOTE: Rotate the chuck body in the direction of the ar-
row marked 

LOCK to tighten the chuck jaws. Do not use 

a wrench to tighten or loosen the chuck jaws.

See Figure 9.


Lock the switch trigger by placing the direction of rotation 
selector in the center position.



Rotate the chuck sleeve clockwise to open the chuck 
jaws.

 

NOTE: Rotate the chuck body in the direction of the ar-
row marked 

UNLOCK to loosen the chuck jaws. Do not 

use a wrench to tighten or loosen the chuck jaws.



  Remove the drill bit.

Fig. 9

Fig.8