Ryobi 5-Speed Power P206 Manuale Utente

13

See Figure 11 - 12.
Levels are located on the top and end of the motor housing 
to help keep the drill bit level during use. 


  Check the direction of rotation selector for the correct 

setting (forward or reverse).



  Secure the material to be drilled in a vise or with clamps 

to keep it from turning as the drill bit rotates.



  Hold the drill firmly and place the bit at the point to be 

drilled.



  Depress the switch trigger to start the drill.



  Move the drill bit into the workpiece, applying only enough 

pressure to keep the bit cutting. Do not force the drill or 
apply side pressure to elongate a hole. Let the tool do 
the work. 

Be prepared for binding at bit breakthrough. When these 
situations occur, the drill has a tendency to grab and kick 
in the opposite direction and could cause loss of control 
when breaking through material. If not prepared, this loss 
of control can result in possible serious injury.



  When drilling hard, smooth surfaces, use a center punch 

to mark the desired hole location. This will prevent the 
drill bit from slipping off-center as the hole is started.



  When drilling metals, use a light oil on the drill bit to keep 

it from overheating. The oil will prolong the life of the bit 
and increase the drilling action. 



  If the bit jams in the workpiece or if the drill stalls, stop 

the tool immediately. Remove the bit from the workpiece 
and determine the reason for jamming.

NOTE: This drill has an electric brake. When the switch trig-
ger is released, the chuck stops turning. When the brake is 
functioning properly, sparks will be visible through the vent 
slots on the hou

sing. This is normal and is the action of the 

brake.

Fig. 11

Fig. 12