Plasmon V15 Manuale Utente

SCSI Menu:

SCSI IDs

Setting SCSI IDs is required for library operation. View the default 
settings and change them if necessary.

Emulation Mode

Setting an emulation mode is required if your application software 
does not support a Plasmon V15.

SCSI Parity

By default, parity checking is enabled. If desired, you can disable 
parity checking for the library if the SCSI adapter card connected 
to the library does not support parity checking. 

Configuration Menu:

Baud Rate

Setting a baud rate is only required for communicating over the 
serial port for firmware upgrades and diagnostics. You do not need 
to set this option for normal library operations.

Clean Slot
Autoclean
Clean Cycles Left

These three options allow you to set up automatic tape drive 
cleaning.
Note: To use automatic cleaning, a cleaning cartridge must be 
installed.

POST Barcode Scan If your software application does not automatically scan barcode 

labels when the library powers up or when the door is opened and 
closed, you can set this option so the library automatically scans 
the labels. By default, this option is turned off when the library is 
shipped.
Note: If your library does not include a barcode scanner, the LCD 
shows “N/A” after the option.

Verify Barcode 
Checksums

This option instructs the library to look for barcode labels with 
checksum characters. If you plan to use barcode labels that 
include checksum characters, you should enable this feature. By 
default, this option is turned off when the library is shipped.
Note: If your library does not include a barcode scanner, the LCD 
shows “N/A” after the option. 

Security Menu:

Security

By setting security, you prevent unauthorized personnel from dis-
rupting the operation of the library through either the LCD keypad 
or the SCSI bus.