PASCO Specialty & Mfg. 1 MHz 2-channel Voltage Sensor PS-2190 Manuale Utente

®

I n s t r u c t i o n   S h e e t

0 12 - 1 02 5 3 A

•

1 MHz 2-channel Voltage Sensor

•

Xplorer GLX datalogger (PS-2002)

•

Patch Cords (SE-9750 or SE-9751)

1. Connect the 1 MHz 2-channel Voltage Sensor to your 

PASPORT Xplorer GLX datalogger.

2. Use patch cords to connect Channel 1 and Channel 2 to the 

parts of the circuit for which you want to measure the volt-
age. 

3. On the Xplorer GLX, press the start button (s) to begin 

recording data.

4. When data recording is done, press the start button again to 

stop recording data. 

The sensor measures up to two voltages simultaneously at speeds 
up to one million samples per second when used with the GLX in 
oscilloscope mode. 

The 1 MHz 2-channel Voltage Sensor is a high speed, two chan-
nel PASPORT voltage sensor that has a basic voltage range of 
±10 volts. It has amplifiers that allow full-scale input ranges of 
±1 volt and ±0.1 volt. The sensor uses an oversampling scheme 
that allows input sampling at speeds up to one million samples 
per second.

The 1 MHz 2-channel Voltage Sensor connects to a PASPORT 
Xplorer GLX datalogger. Measurements are recorded and dis-
played by the datalogger.

Plug the sensor into any port on the top of the PASPORT Xplorer 
GLX datalogger. The Xplorer GLX screen will automatically 
show a Graph display of voltage versus time. 

Sample rate, data averaging, and input voltage range are set in the 
Sensors screen.

•

Press the Home button (h) to open the Home screen.

•

Press  F4  (I) under Sensors in the Home screen to open 
the Sensors screen.