NEC 2400 PX Manuale Utente
NEAX2400 IPX Feature Programming Manual
Page 228
NDA-24297, Issue 1
C-69
Call Forwarding - All Calls - Announcement
Programming (cont’d)
STEP 4:
ATRK
- Assign the LENs. Announcement Trunk Route Number, Trunk Number, and Tenant Number.
Assign one or more trunks to a specific route used to connect to an announcement machine.
STEP 5:
MBTK
- Assign the Make Idle status to the announcement trunk.
STEP 6:
ADSL
- Assign SN=1 (Originating; DT Connection) and FKY=2 (Call Forwarding - All Calls; FDA).
This command is used for assigning the function for each soft key.
STEP 7:
ARRC
- If a TIE Line, DID or REMOTE ACCESS TO PBX [R-2] connection to the Announcement
Service trunk is required, allow trunk-to-trunk connection using ARI-D-RES, Direct Connection.
STEP 8:
AAED
- Used to assign announcement equipment.
Assign:
TN:
Tenant Number
EQP:
Announcement Equipment Number
0: Dead Level
0: Dead Level
1: Unused Number (LCR OPR not programmed)
2: Available
2: Available
3: Available
4: Outgoing Trunk Group Busy Announcement
5: Available
4: Outgoing Trunk Group Busy Announcement
5: Available
6: Available
7: Outgoing Route Restriction Announcement
7: Outgoing Route Restriction Announcement
8-15: Available for ANNOUNCEMENT SERVICE [A-15] applications
RT, TK:
Route and trunk number of the trunk connected to the announcement equipment
C:
Duration of Connection, 0/1: Disconnection occurs in 30 seconds/ the connection is held
until the station releases. See the requirements of the announcement equipment.
until the station releases. See the requirements of the announcement equipment.
R:
Sending RBT, 0/1: Sending RBT/Not Sending RBT. Normally assign data “0”.
A:
Answer Signal Sending, 0/1: No answer from Incoming trunk/Answer from Incoming
trunk. Normally assign data “0”. No answer signal is sent to the C.O. Therefore, calling
party will not be billed for the call.
trunk. Normally assign data “0”. No answer signal is sent to the C.O. Therefore, calling
party will not be billed for the call.
M:
Multiple Connection 0/1: Single Connection/Multiple Connection. See the requirements
of the announcement equipment.
of the announcement equipment.