NEC 2400 PX Manuale Utente
NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
NDA-24297, Issue 1
Page 385
Hotline - Outside
H-9
FCCS Programming
This data setting describes only the additional or replacement commands used to activate FCCS
services. When used as an FCCS feature, these commands replace the non-network commands (for
example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending
on the node.
services. When used as an FCCS feature, these commands replace the non-network commands (for
example, AAED is replaced by AAEDN). Note that the data setting for FCCS service varies depending
on the node.
Note 1
AHLSN
- This data must be assigned to the NCN:
UGN:
User Group Number of the calling party
TELN:
Telephone Number of the calling party
TYPE:
2 (The called party is an outside party)
3 (The called party is a trunk)
3 (The called party is a trunk)
CON UGN:
User Group Number of the called party (for TYPE=2)
CON ADC:
The dialed number for the called party (for TYPE=2)
CON LRN:
Logical Route Number of the called party (for TYPE=3)
CON TK:
Trunk Number of the called party (for TYPE=3)
Note 1:
When using ASYDL or ASYDN to program an FCCS feature, the basic programming of ASYD is required
in addition to ASYDL or ASYDN.
in addition to ASYDL or ASYDN.
Note 2:
The current data should also be set in addition the above-mentioned command. The command to be set to
the node accommodating the calling party: ASYD/ASFC/ASDT/ASP
the node accommodating the calling party: ASYD/ASFC/ASDT/ASP