NEC EXPRESS 5800 Manuale Utente
Setting Up Your System 2-19
Connection between the Front Serial Port and a Management PC (DB9)
To connect equipment such as a management PC having a DB9-type serial connector to the
system via the serial port on the front panel, use the optional "serial port conversion cable" with
the "F" label attached. Be careful not to use the other one with the "R" label attached.
system via the serial port on the front panel, use the optional "serial port conversion cable" with
the "F" label attached. Be careful not to use the other one with the "R" label attached.
NOTE:
You do not have to change the setting of the jumper pin when
connecting to the serial port on the front panel of the server.
Connection between the Rear Serial Port and a Modem
To connect a modem to the serial port on the rear panel, use the optional "serial port conversion
cable" with the "R" label attached. Be careful not to use the other one with the "F" label attached.
Set the jumper pin to "DCD+DSR" (factory-set).
cable" with the "R" label attached. Be careful not to use the other one with the "F" label attached.
Set the jumper pin to "DCD+DSR" (factory-set).
IMPORTANT:
Make sure of the icon on the rear panel of the server, and
be sure to connect the cable to serial port 2. Be careful not to connect to a
LAN port by mistake.
To prevent wrong connection, write "LAN port" on a tag and put the tag
to the connector of the LAN cable that is to be connected to this server.
LAN port by mistake.
To prevent wrong connection, write "LAN port" on a tag and put the tag
to the connector of the LAN cable that is to be connected to this server.
Connection between the Rear Serial Port and a UPS
To connect a UPS to the serial port on the rear panel, use the optional "serial port conversion
cable" with the "R" label attached. Be careful not to use the other one with the "F" label attached.
Set the jumper pin to "DCD+DSR" (factory-set).
cable" with the "R" label attached. Be careful not to use the other one with the "F" label attached.
Set the jumper pin to "DCD+DSR" (factory-set).
IMPORTANT:
Make sure of the icon on the rear panel of the server, and
be sure to connect the cable to serial port 2. Be careful not to connect to a
LAN port by mistake.
To prevent wrong connection, write "LAN port" on a tag and put the tag
to the connector of the LAN cable that is to be connected to this server.
LAN port by mistake.
To prevent wrong connection, write "LAN port" on a tag and put the tag
to the connector of the LAN cable that is to be connected to this server.
Connection between the Rear Serial Port and a Management PC (DB9), etc.
To connect equipment such as a management PC having a DB9-type serial connector to the serial
port on the rear panel, use the optional "serial port conversion cable" with the "R" label attached.
Be careful not to use the other one with the "F" label attached. Set the jumper pin to
"DCD+DSR" (factory-set).
port on the rear panel, use the optional "serial port conversion cable" with the "R" label attached.
Be careful not to use the other one with the "F" label attached. Set the jumper pin to
"DCD+DSR" (factory-set).
IMPORTANT:
Make sure of the icon on the rear panel of the server, and
be sure to connect the cable to serial port 2. Be careful not to connect to a
LAN port by mistake.
To prevent wrong connection, write "LAN port" on a tag and put the tag
to the connector of the LAN cable that is to be connected to this server.
LAN port by mistake.
To prevent wrong connection, write "LAN port" on a tag and put the tag
to the connector of the LAN cable that is to be connected to this server.