Korg Toneworks AX1500G Manuale Proprietario

The power must be off when you make connections.
Unintentional operation may damage your speakers, or
cause malfunctions.

1. Connect your cables from the OUTPUT jacks of the

 to your guitar amp or mixer etc.

If you are using a mono connection, connect the L/
MONO jack. In order to take full advantage of the
AX1500G

’s sound, we recommend that you use

stereo connections.

2. If you wish to use headphones, plug them into the

PHONE jack.

The output from the OUTPUT jacks will be turned off
when headphones are plugged in.

3. Connect your guitar to the INPUT jack.

4. If you wish to use the AUX IN jack, connect an

external audio device to it. Use the controls of the
connected device to adjust the volume.

5. Connect the included AC adapter to the DC 9V jack,

and plug the AC adapter into an AC outlet. When
you plug it in, the power will come on automati-
cally, and the name display will indicate the
program name.

Wrap the AC adapter cable around the cable hook. When
removing the cable from the hook, be careful not to pull
the cable with excessive force.

6. When you have finished making connections, turn

on the power of your guitar amp or mixer etc. Play
your guitar, and check whether connections have
been made correctly. Adjust the master level of the
AX1500G

 and the gain or fader controls of your

guitar amp or mixer to set an appropriate volume
level.

DC9V

INPUT

OUTPUT

AUX IN

Headphones

Audio device

Stereo-mini

Guitar

mono

Guitar amp etc.

Stereo-mini

Included AC adapter

Mono phone plug

User

program

Preset

program

When you turn on the power, the AX1500G will
always enter Play mode, and will be set to the
program and master level setting that were last
selected when the power was turned off.

The MASTER/VALUE display will show the master
level immediately after the power is turned on, a
program is selected, and after the EXIT switch is
pressed.
When the master level is shown, you can use the
MASTER/VALUE 

switches (▲, ▼) to adjust the master

level.

You can select from 48 preset programs and 48 user
programs.
User and preset programs are each organized into 16
banks, with three programs in each bank. The cur-
rently selected bank is shown by the bank
number display, and the program is
shown by the program LEDs. To switch
between user and preset programs,
simultaneously press MASTER/VALUE
switch (▲) and cursor switch (®). When a
user program is selected, a decimal point
“

” located at the lower right of the bank

number display will light.

To select a program in the same bank
Press a program switch 1—3 to select the desired
program. The program LED of the selected program
will light, and the name display will indicate the
program name.

To select a program from a different bank
Press the bank switch to select the desired bank. (The
bank number display will blink.) The banks will cycle
in the order 0, 1, 2, ...9, A, b, C, d, E, F, 0, 1, 2...
• Each time you press the bank switch, the bank

number display will increase by one.

• Each time you simultaneously press the bank

switch and program switch 3, the bank number
display will decrease by one.

When the desired bank number appears, press
program switch 1,2 or 3 to select the desired program.
(The bank number display will change from blinking
to lit.)

Not every program uses all of the effect blocks. When
you select a program, the LED of each effect block that
are used will light. The LEDs of effect blocks that are
unused will be dark.