MRV Communications EM316-2SFP Manuale Utente

 

 

EM316-2SFP User Guide 

 

 
P/N 1259003-001 Rev C3 

 

40 

 

 

 
Default settings are listed in the show defaults command output. These parameters 
reflect the module boot configuration which is determined by DIP switches and firmware 
programming. All lines in this display begin with “!” to indicate that they are comments for 

information only. 
 

 

 

 
 

 
The  show config command displays the active environment settings currently in the 
operational context. The lines beginning with “!” are comments added for clarity in the CLI 

display only. The comment lines ending with “:” are headings that describe the settings listed 
in this display. 
 

 

 
The default parameter values are constant for each module, but can change to reflect DIP 
switch settings. Changes to these parameter values are reflected in the show config 
command output. Restoring the default values returns the module to its original operating 
state. Preserve changes made to the configuration for use in future CLI sessions and beyond 

a reboot by writing them to the startup-config file as described later in this section. 
 

fiberdriver(port/1.1.1)# show config 
port 1.1.1 
 ! Configured parameters that override defaults: 
 ! Configured parameters that match defaults: 
 ! Parameters that will follow defaults: 
 ! no loopback 
 ! no shutdown 
 ! lin 
 ! description SFP at 1.1.1 
 ! rm-chassis 0 
 ! rm-slot 0 
 ! rm-port 0 
fiberdriver(port/1.1.1)# 

fiberdriver(port/1.1.1)# show defaults 
port 1.1.1 
 ! no loopback 
 ! no shutdown 
 ! lin 
 ! description SFP at 1.1.1 
 ! rm-chassis 0 
 ! rm-slot 0 
 ! rm-port 0 
fiberdriver(port/1.1.1)#