Mermaid REFRIGERATION/FREEZER Manuale Utente
Mermaid’s 12/24VDC model or our 12/24VDC & 110V with Auto Change-Over model,
we are sure you will be pleased with their performance.
Mermaid provides a one-year warranty on the refrigeration/freezer products and a five-
year warranty on their marine air conditioning line. In the unlikely event of any issue,
Mermaid will take the necessary steps to ensure your complete satisfaction.
Thank you for the business and we look forward to hearing of your success!
Regards,
John D. Trotter
Vice President
we are sure you will be pleased with their performance.
Mermaid provides a one-year warranty on the refrigeration/freezer products and a five-
year warranty on their marine air conditioning line. In the unlikely event of any issue,
Mermaid will take the necessary steps to ensure your complete satisfaction.
Thank you for the business and we look forward to hearing of your success!
Regards,
John D. Trotter
Vice President
SECTION 2
(CONDENSER INSTALLATION)
A: Mounting Position:
These units should be mounted in a cabinet or area where they will not be susceptible to
physical or water damage. There should be adequate ventilation of the compartment to
allow the warm air to be expelled, but not so that it can be immediately drawn back in.
The efficiency of the system depends mainly on the temperature of the air entering the
condenser. Re-circulating the heated air back into the condenser in a sealed or poorly
ventilated cabinet will result in poor system performance, as will drawing in air from a
heated space, i.e. engine room.
physical or water damage. There should be adequate ventilation of the compartment to
allow the warm air to be expelled, but not so that it can be immediately drawn back in.
The efficiency of the system depends mainly on the temperature of the air entering the
condenser. Re-circulating the heated air back into the condenser in a sealed or poorly
ventilated cabinet will result in poor system performance, as will drawing in air from a
heated space, i.e. engine room.
B: Installation
These units are designed to be mounted on a surface where adequate ventilation can pass
around the unit. This can either be from an adjacent cabinet or a custom “return air”
grille no smaller than a 6” x 6” grill.
around the unit. This can either be from an adjacent cabinet or a custom “return air”
grille no smaller than a 6” x 6” grill.
Mount the unit by securing with screws through the base, making sure that the condenser
lines up with the ventilation hole. Best results are achieved with the unit if the condenser
frame is sealed against the bulkhead with foam rubber tape or equivalent. The ventilation
hole should be covered with a suitable grill to protect the condenser fins from damage, &
for aesthetic appeal. The grill must be of sufficient size & construction so as not to
impede air flow.
lines up with the ventilation hole. Best results are achieved with the unit if the condenser
frame is sealed against the bulkhead with foam rubber tape or equivalent. The ventilation
hole should be covered with a suitable grill to protect the condenser fins from damage, &
for aesthetic appeal. The grill must be of sufficient size & construction so as not to
impede air flow.