Lightwave Communications SCS3230 Manuale Utente

A Lantronix Company  

 

SCS3230 System Administrator's Guide  

15.00.038

 

 - 75 - 

May 2002 

 

 
Each terminal card has four (4) RJ45 connector ports to which a terminal may be attached, 
giving a maximum of 16 physically connected terminals per SCS3230 unit.  The terminal card 
may be installed in slots B, C, D, or E. 
 
To access servers through the SCS3230 terminal card, the user must have at least a text 
terminal capable of serial communication, a serial cable terminating in an RJ45 connector, and 
the proper serial communication settings as determined by the system administrator.  The 
default communication settings are 38400, N, 8, or 1. 
 
Once the hardware is properly connected and configured, the user may issue commands to the 
terminal card.  Before entering any commands, the user should be sure that the terminal card is 
ready to accept commands by checking that there is a prompt on screen.  This is best 
accomplished by pressing 

<ENTER> until a prompt appears on the screen (a prompt will not 

appear on the screen if the terminal port is in direct mode, or if the serial cable is not connected 
properly). 
 

 
The network card must be connected to a network that uses TCP/IP.  There is one 10/100 IP 
Network port, part of the NETWORK/CONTROL card.  
 
Network settings are entered via the Sys Admin port. 
 
To connect to the SCS3230 network card, the user should use a TCP/IP telnet client to telnet to 
the IP address assigned to the network card. 
 

 

OCTANE_65 10# TELNET 172.16.1.31 

Trying 172.16.1.31... 
Connected to 172.16.1.31 
Escape character is ‘^]’. 
 
Welcome to the SCS3230 
You are connected to Port 5 via 172.16.1.31 
 
 
LCI3200> 

 

 

8:   User Access and Interface